User Tools

Site Tools



This page discusses how to get the I2C interface to the external EEPROM working so users can save data to NVM.
Questions? - mbmoessner mbmoessner and - anparks anparks donated this source code.


In almost all cases, the WISP_4.1 boards (blue WISPs) have 1.8v regulators and 2.0v supervisors. Thus, the user can not reliably save data to the MSP430’s internal 2.2v FLASH. (Lower operating voltage gives the WISP better range).

We included 8k of 1.8v EEPROM (24AA08) on the I2C bus, but it requires some code to talk to the EEPROM chip from the MSP430.

Source Code

There is now code in the community repository for interfacing with the EEPROM as well. This code was adapted from Markus Moessner's by Shane Clark and includes the use of LPM3 to sleep while waiting for EEPROM operations to finish — rather than busy waiting as the original code does.

Here are some easy-to-use routines for reading/writing from/to the 24AA08 EEPROM, based on Markus Moessner's work (below). Tested and working on the WISP 4.1 DL. Contact - anparks anparks with questions/comments.

Markus Moessner's original source code for interfacing the MSP430 to the 24AA08 EEPROM, along with a guide to using it.

Other Resources

EEPROM data sheet:

TI application note for interfacing EEPROM to the MSP430 using the I2C Module:

The TI application notes and code example are for a similar EEPROM (24xx65 type). However, I’m told that there is a compiler issues with newer versions of IAR work bench. At least this is a starting point.

The last modification was made by - yeagerd yeagerd on Apr 26, 2012 9:28 am

eeprom.txt · Last modified: 2018/07/11 08:25 (external edit)